PriceList For Spiral Weld - Fusion-Bonded Epoxy Coatings Awwa C213 Standard – Spiral
PriceList For Spiral Weld - Fusion-Bonded Epoxy Coatings Awwa C213 Standard – Spiral Detail:
Physical properties of epoxy powder materials
Specific gravity at 23℃: minimum 1.2 and maximum 1.8
Sieve analysis: maximum 2.0
Gel time at 200 ℃: less than 120s
Abrasive blast cleaning
Bare steel surfaces shall be abrasive blast-cleaned in accordance with SSPC-SP10/NACE No. 2 unless otherwise specified by the purchaser. The blast anchor pattern or profile depth shall be 1.5 mil to 4.0 mil(38 µm to 102 µm) measured in accordance with ASTM D4417.
Preheating
Pipe that has been cleaned shall be preheated at temperature less than 260℃, the heat source shall not contaminate the pipe surface.
Thickness
The coating powder shall be applied to the preheated pipe at a uniform cure-film thickness of not less than 12 mils(305μm) on the exterior or interior. The maximum thickness shall not exceed a nominal 16 mils(406μm) unless recommended by the manufacturer or specified by the pruchaser.
Optional epoxy performance testing
The purchaser may specify additional testing to establish epoxy performance. The following test procedures, all of which shall be performed on production pipe test rings, may be specified:
1. Cross-section porosity.
2. Interface porosity.
3. Thermal analysis (DSC).
4. Permanent strain (bendability).
5. Water soak.
6. Impact.
7. Cathodic disbondment test.
Product detail pictures:
Related Product Guide:
The key to our success is Good Products Good quality, Reasonable Value and Efficient Service for PriceList For Spiral Weld - Fusion-Bonded Epoxy Coatings Awwa C213 Standard – Spiral , The product will supply to all over the world, such as: New Delhi, Tunisia, Sierra Leone, We set a strict quality control system. We have return and exchange policy, and you can exchange within 7 days after receive the wigs if it is in new station and we service repairing free for our products. Please feel free to contact us for further information if you have any questions. We are glad to work for every client.
By jari dedenroth from Jordan - 2017.12.02 14:11
The factory workers have rich industry knowledge and operational experience, we learned a lot in working with them,we are extremely grateful that we can encount a good company has excellent wokers.
By Yannick Vergoz from Vietnam - 2018.11.22 12:28
